pbanna.blogg.se - Black and white wireless credit card terminal

#Black and white wireless credit card terminal password#
#Black and white wireless credit card terminal download#

However, it is essential to consider the care instructions for each fabric type. Should you require assistance in doing this, please contact Valitor Technical Support.LG top-load washing machines are suitable for a variety of fabrics. If your PAX terminal does not have a battery,simply remove the power cable from the unit. Remove any cables connecting to a base station (if you have one).Ensure the battery is kept in a safe location, where it will not overheat.

Slide the battery out of its compartment.

Remove the back cover by sliding the lock and lifting the cover.

Power down the terminal by holding down the power button on the side and choosing ‘Power off’ on the screen.

If you do not do this, you may experience a blue screen or failure to power, and the battery or even the terminal will require replacement. If your terminal(s) will be inactive for a significant period of time - longer than a week - you should remove the power source in order to protect them.

Check that email receipts is enabled on the POSitive app.

Under APP settings make sure print to screen is enabled.

Under APP settings you can enable “Auto Log On”.

Under APP settings you can disable “Auto Log Off”.

#Black and white wireless credit card terminal password#

Make sure that the “Save credentials” box is checked BEFORE user id and password are keyed in.The Reprint options can be used to produce copies of lost receipts or reports.The History report prints the last 8 transactions.PAX terminals do not print an itemized End of Day only do totals.Check to see if roller bar is stuck inside machine not in lid.Make sure roller bar is not stuck inside the terminal (not in lid).Check the roller bar and printer lid for damage.Confirm the terminal has more than 10% battery.Contact Valitor Technical Support, who will assist in resolving the issue.Try charging through the side port as this is usually more efficient.Change display settings (Brightness and Sleep timer)and monitor for improvement.Try a different micro usb cable if one is available.Change the power plug the charger is using and attempt the above steps.Clean the gold connection plates on base + terminal.Ensure that everything is plugged in correctly and no damage to wires etc.Charge the terminal through the side port.Inspect the machine for damage (photos can be submitted to Valitor Technical Support.This is an “Alert Irruption” and the terminal will need to be replaced. If this is the issue move onto connection troubleshooting, as described above. Test the Acquiring Connection (should be very quick). If possible, swap connection types (so from WIFI to 4g for example). Check that the connection type is working.Check network service status in the area.Remove sim card – restart – reinsert sim and restart again.Scan for a different network – cellular settings – network operators.Confirm that the cellular settings and APN settings are correct.Take the machine to another WIFI to confirm terminal issue not a site issue.Connect to a mobile hotspot to confirm terminal issue not site issue.If the terminal has a sim card, swap to 3/4g connection Restart the internet router and then card machine.Check the WIFI settings to make sure it says “Connected” under the correct networkĪn authentication error/problem means the WIFI password was not put in correctly.You will see the Home screen displayed when the problem resolves. It can be resolved by pressing the Power and Volume Down buttons at the same time, and holding them down for several seconds.

#Black and white wireless credit card terminal download#

This can happen if a firmware download was interrupted, if, for example, the terminal was low on battery or turned off mid download. Test the machine after each attempted solution by attempting a transaction for 1p.